Services

Schoop process

Some people call this metallising, while others call this after-treatment the Schoop process or zinc spraying. At Ulamo, we usually speak of Schoop process, because this process was invented in the early twentieth century by the Swiss engineer Schoop.

What is the Schoop process?

The purpose of the Schoop process is to make the metal more resistant to rust and oxidation. During the Schoop process, a high-quality and rust-resistant zinc layer is applied to the surface that has been pre-blasted. The Schoop process is performed with a flame, the corrosion-resistant metal zinc and a flame spray gun. The flame heats the zinc so that it becomes a liquid. The molten material is then deposited on the product surface to be protected. The molten zinc adheres to it as small spatters. As the process progresses, a dense layer is created that protects the material even better against corrosion.

Why use the Schoop process?

We advise using the Schoop process if your steel products that need to be powder-coated have an outdoor application. After blasting and applying the Schoop process, they usually receive a two-layer system. They are therefore extremely resistant even to conditions that are highly corrosive.

Maximum dimensions for the Schoop process

7,000 x 2,000 x 2,600 mm
The maximum capacity is limited when the maximum length, breadth or depth measurements are reached.
Do you need more information about the Schoop process? Call us on +31 (0)315 – 688 688.

7148_ulamo_8a

Top-quality products are the starting point

In everything we do, starting from the arrival of the products, we are focused on quality. Ulamo Coating powder coat for fa├žade builders and manufacturers of street furniture, sun protection, partition walls, air treatment systems is involved as a powder coating company in leading architectural projects.