Services

Blasting

Manual blasting has been a proven and effective mechanical pre-treatment at Ulamo Coating for years. This is how we remove rust, mill scale, annealing scale and other coatings. By blasting in the right way, a clean, rough base material with a so-called good anchor pattern is created. This is then suitable for further surface treatment.

What is blasting?

During blasting, blasting grit is blown against or along the object in a certain mixing ratio with air and pressure. This is done in a closed blasting booth. Before a product is blasted, we protect threaded, rotating parts, axle journals and other vulnerable parts. For blasting, the following applies: the harder the material, the easier it is to blast. Because rust has a hard structure, blasting is a good way to remove rust.

Strict environmental requirements

At Ulamo, we blast in special blasting booths. These booths have a steel floor and walls covered with rubber. An extraction system removes the released dust. The blaster is well protected during his work; he wears a blasting suit, boots, gloves and an overpressure helmet with external air supply.

After blasting

Because flash rust can start again after blasting at lightning speed, we perform the after-treatment quickly. Our starting point? When it’s still warm from the blasting! For outdoor applications, we metal-spray the products after blasting. This creates the perfect adhesion layer.

Maximum dimensions for blasting

7,000 x 2,000 x 2,600 mm
The maximum capacity is limited when the maximum length, breadth or depth measurements are reached.

Do you need more information about blasting? Call us on +31 (0)315 – 688 688.

7148_ulamo_8b

Top-quality products are the starting point

In everything we do, starting from the arrival of the products, we are focused on quality. Ulamo Coating powder coat for façade builders and manufacturers of street furniture, sun protection, partition walls, air treatment systems is involved as a powder coating company in leading architectural projects.